Post by ladon on Apr 28, 2019 21:51:08 GMT -6
I have an older Razot car. 2009 I believe. Decent car and I don’t believe it is the best car out there but I think it can be better than it is. Where my problem is I believee is my left rear will hike up ok but it seems when it does it hikes the whole rear of the car. I have no body roll.like other cars. My car pushes hard in the middle of the corner and then is big loose off. Now I have to admit I am fairly new at this so some might be a little inexperience. I am kind of thinking I am off in two areas. First the pull bar. It have an 18 degree slope I. It and it is approx 24” long center to center. I am thinking maybe I should move it to then right some to help this if I understand it right. Also might be a little too much angle in my right bar? Thinking it is about 16 degrees. Here is the rest of the setup. Rr spring 175. Lr 200. Rf 550 lf 500. Shocks I don’t remember right away but we’re just done last week by Troy at Zero 1. I believe he pretty much know what he is doing as a lot of cars here work fine with his stuff. Left rear bar is approx 22 degrees. Right now both bars are 16.2 inches long. Percent rear is 56.3 and left is 52.4. With approx 80 for bite. Razor says 20 for bite with no driver but that don’t seem to work. Lf caster is 2 and right is 5 with left front camber at 4 and right front at 5. Compared to other cars I just am not rolling over like them. Car is very flat in the corners. Other thing is even in the pits just turning left all other cars even hike up then but mine don’t. Just a little and that is it. Nothing like theirs. Anyone got any ideas? Thanks