Post by kyleh2486 on Oct 4, 2015 20:59:03 GMT -6
I am preparing a car for my first endeavor into racing. I'll be racing at valley speedway in grain valley, mo in the dirt demon class. Dirt demon is a 4 cylinder starter class. I've never build a car before and the only rules I'm not totally clear on are about the roll cage. Can anyone give me any input? Pictures would be the best if you have the same set up.
A six-point roll cage is mandatory. Cage must be welded to 2” by 2” square tubing that is welded to the rocker panelsand the floor. Roll cage tubing must be minimum of 1 1⁄2” by .095 highly recommended 1 3⁄4” by .095. A minimum of three door bars is required on driver’s side. Earnhardt bar must be installed.
A six-point roll cage is mandatory. Cage must be welded to 2” by 2” square tubing that is welded to the rocker panelsand the floor. Roll cage tubing must be minimum of 1 1⁄2” by .095 highly recommended 1 3⁄4” by .095. A minimum of three door bars is required on driver’s side. Earnhardt bar must be installed.