|
Post by jsheets on Jun 15, 2014 18:19:24 GMT -6
I have installed a valve cover breather and attached it to my header to act like a vacuum in my pro mini mustang. I had a little pin hole beside my hose attachment on my header i missed when i welded it and notice that it was sucking oil out of my valve cover and i remove the hose and the inside of the hose is covered in oil. Is that normal and if not how can i stop it. Thanks
|
|
|
Post by flipflopoo1oo on Jun 16, 2014 5:38:18 GMT -6
Baffle is used in the block! A must for 2300 Fords. A longer higher vent hose before falling! The larger the better as to limit flow by letting it breathe and drain back into the motor! New baffle warranted as they clog-up and are a filtered design!
|
|