|
Post by mchizy on Mar 23, 2013 21:19:53 GMT -6
try to set front ride height and camber on harris sq tube afco a arms set degree and am on the floor and cant set driver side cammber in jack bolts and still not far enough have pinto spindels standard uper ball joint 1 in taller lower ball joint any help set uper a arms at 14.5 deg and right at 15 car is almost on the ground Thanks mike
|
|
|
Post by dirtbandit on Mar 24, 2013 18:46:20 GMT -6
Which upper a arms are you running? (8 3/4" both sides?) How old of a chassis? I have had a 1998, 2006, 2008 and a 2009. All are close to the jack bolt. On the later cars, Harris has instructed to go to a 9" on the lf and a 8" on right front. Has helped with clearance some. Depending on the year of the chassis, ride heights were measured a little differently (i.e. 98 chassis had tabs welded on above front of lower a arm by spring bucket to measure.) I am guessing that it is a 2006 or older chassis. It does seem that when I was setting my cars by upper control arm angle that the car was always very low in the front compared to other chassis. Now we use the lower a - arm bolt to the ground as our measurement ( upper arm angles are not quite what you are listing).
|
|
|
Post by snappytom on Mar 25, 2013 20:00:29 GMT -6
I have an 05. I too have gone to a 9 1/4" left A arm and use the lower control arm front bolt to the ground as a measurement. I use 7 3/4"-7 7/8" left side and 7 3/4"-8" right side which will make my upper arm angles approx 12* left and 13* right
|
|
|
Post by dirtbandit on Mar 28, 2013 10:03:27 GMT -6
I basically use the same the as snappytom but reverse his right and left side heights.
|
|