|
Post by 46monte on Nov 21, 2022 20:30:26 GMT -6
What is a good starting point for ride heights on a metric street stock car for dirt
|
|
|
Post by racer5056 on Jun 22, 2023 15:49:24 GMT -6
Find the center of the ball joint on your front lower control arms. It's usually where the lip starts to form. Follow that over to the bolt where the control arms pivot. Set the right side's bolt 1/2" lower than what the right side ball joint measured. Do the same thing on the left side but make the bolt the same exact height at the left side's ball joint. That should set the left side level. Take a small level and put it under the spring cup on the left lower control arm and you should see it read level.
The rear should be between 1/2" to 1 1/2" higher than what your front measurements are. This will be a good starting point.
|
|